''WELCOME TO THE INSTRUCTION PAGE''

FOLLOW THESE INSTRUCTIONS FOR THE PEFECT RESULT


FULL INSTRUCTIONS BELOW THESE ARE INCLUDED WITH EVERY PURCHASE.

----------------------------------------------------------------------------------------------

BEFORE CLEANING REMOVE ANY SOLID MATTER SUCH AS CANDLE GREASE.

USE A PLASTIC ENAMEL, STAINLESS STEEL OR CHINA BOWL OR SINK. DO NOT USE ALUMINIUM.

WARNING:
ALUMINIUM USED WITH THIS PRODUCT MAY BECOME TOXIC DUE TO THE CRYSTALS USED
please read instructions on bag when you purchase soda crystals

REQUIREMENT WASHING SODA (SODIUM CARBONATE CRYSTALS) SODA IS REQUIRED TO PRODUCE AN ALKALINE SOLUTION TO ACT AS A CONDUCTOR FOR THE PLATE ADD ONLY ONE DESSERT SPOON OF SODA FOR EACH 2 PINTS OR 1 LITRE OF WATER USED.

FIRST TIME OF USE ' PLACE THE PRISTINE PLATE IN THE BOTTOM OF THE BOWL OR SINK AND SPREAD THE REQUIRED AMOUNT OF SODA OVER IT. POUR SUFFICENT BOILING WATER INTO THE BOWL TO JUST COVER THE PLATE. LEAVE FOR 2 MINUTES ' THIS WILL ,,SEASON,, THE PLATE. AFTER 2 MINUTES ADD THE REQUIRED AMOUNT OF WATER FOR CLEANING.

SUBSEQUENT USE ' PLACE THE REQUIRED AMOUNT OF SODA IN THE BOWL OR SINK, AND ADD THE AMOUNT OF VERY HOT WATER TO BE USED.

IMMERSE THE ARTICLES TO BE CLEANED MAKING SURE THAT ONE PART OF EACH ARTICLE IS EITHER TOUCHING THE PLATE OR ANOTHER ARTICLE WHICH IS ITSELF IN CONTACT WITH THE PLATE.

ELECTROLYTIC ACTION CLEANS ALL ARTICLES AT THE SAME TIME, TAKING 30 SECONDS TO 1 MINUTE TO DO SO.

RINSE WELL IN CLEAN, HOT SOAPY WATER AND DRY WITH A CLEAN SOFT CLOTH, FOR A SPARKLING PRISTINE FINISH.

AS SOON AS CLEANING IS COMPLETED REMOVE THE PRISTINE PLATE FROM THE WATER.

FOR BRASS COPPER AND BRONZE 'USE LARGE CUP OF WASHING POWDER (e.g. DREFT etc.) WITH SODA CRYSTALS.

ARTICLES TOO LARGE TO BE IMMERSED COMPLETELY CAN BE CLEANED BY TURNING UNTIL THE ARTICLE HAS BEEN CLEARED.

TRUE BRASS OR TRUE COPPER ' WHICH HAS BEEN PREVIOUSLY CLEANED USING METAL POLISH WILL HAVE ACQUIRED A FILM OF OIL ON ITS SURFACE, BEFORE USING PRISTINE, ENSURE YOU REMOVE THE OILY FILM WITH HOT SOAPY WATER, TO ENSURE A PRISTINE CLEAN.

FOR BEST RESULTS CLEAN DIFFERENT METALS WITH FRESH HOT WATER WITH SODA ADDED.
JEWELLERY CLEANING PLACE THE ITEM TO BE CLEANED ON THE PRISTINE PLATE AND IMMERSE FOR APPROXIMATELY 20 SECONDS. RINSE WELL AND DRY ON A SOFT CLEAN CLOTH.

IF THE ITEM/S ARE/ IS A RING SET WITH STONES, AFTER 15 SECONDS BRUSH THE SETTING GENTLY WITH A SOFT BRISTLE TOOTHBRUSH, TO REMOVE ANY SOAP OR HAND CREAM FROM THE SETTING. IMMERSE AGAIN FOR 20 SECONDS AND RINSE AND DRY AS ABOVE.

DO NOT IMMERSE OPELS OR PEARLS JEWELLERY SHOULD ONLY BE CLEANED IN HAND HOT WATER

LACQUERED ARTICLES ' LACQUER CAN BE REMOVED WITH PRISTINE.

MAKE A SMALL BREAK IN THE LACQUER, AND IMMERSE THE ARTICLE IN HOT SOLUTION, TOUCH THE PLATE AND WITHIN A FEW MINUTES THE LACQUER WILL LIFT OFF.

TO MAINTAIN THE EFFICIENCY OF YOUR PRISTINE PLATE ' AFTER USE RINSE THE PLATE UNDER A RUNNING TAP GENTLY RUBBING BOTH SIDES, DRY IN THE AIR AND STORE IN THE FOLDER IT COME,S WITH IN A DRY CLEAN PLACE, GIVE AN OCCASIONAL RUB OVER WITH A BRILO PAD OR SIMILAR WIRE WOOL. TO MAINTAIN A HEALTHY PLATE..

Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×